74ACT715

74ACT715, 74ACT715-R Programmable Video Sync Generator

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

74ACT715, 74ACT715-R Programmable Video Sync Generator

April 2007

74ACT715, 74ACT715-R Programmable Video Sync Generator
Features
Maximum Input Clock Frequency 130MHz Interlaced and non-interlaced formats available Separate or composite horizontal and vertical Sync

General Description
The ACT715 and ACT715-R are 20-pin TTL-input compatible devices capable of generating Horizontal, Vertical and Composite Sync and Blank signals for televisions and monitors. All pulse widths are completely definable by the user. The devices are capable of generating signals for both interlaced and noninterlaced modes of operation. Equalization and serration pulses can be introduced into the Composite Sync signal when needed. Four additional signals can also be made available when Composite Sync or Blank are used. These signals can be used to generate horizontal or vertical gating pulses, cursor position or vertical Interrupt signal. These devices make no assumptions concerning the system architecture. Line rate and field/frame rate are all a function of the values programmed into the data registers, the status register, and the input clock frequency. The ACT715 is mask programmed to default to a Clock Disable state. Bit 10 of the Status Register, Register 0, defaults to a logic "0". This facilitates (re)prog
ramming before operation. The ACT715-R is the same as the ACT715 in all respects except that the ACT715-R is mask programmed to default to a Clock Enabled state. Bit 10 of the Status Register defaults to a logic "1". Although completely (re)programmable, the ACT715-R version is better suited for applications using the default 14.31818MHz RS-170 register values. This feature allows power-up directly into operation, following a single CLEAR pulse.

and Blank signals available Complete control of pulse width via register programming All inputs are TTL compatible 8mA drive on all outputs Default RS170/NTSC values mask programmed into registers ACT715-R is mask programmed to default to a Clock Enable state for easier start-up into 14.31818MHz RS170 timing

Ordering Information
Order Number
74ACT715SC 74ACT715-RSC

Package Number
M20B M20B

Package Description
20-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-013, 0.300" Wide 20-Lead Small Outline Integrated Circuit (SOIC), JEDEC MS-013, 0.300" Wide

Device also available in Tape and Reel. Specify by appending suffix letter "X" to the ordering number.

FACTTM is a trademark of Fairchild Semiconductor Corporation. 1988 Fairchild Semiconductor Corporation 74ACT715, 74ACT715-R Rev. 1.3 www.fairchildsemi.com