FPF2005

FPF2000-FPF2007 IntelliMAXTM Advanced Load Management Products

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

FPF2000-FPF2007 IntelliMAXTM Advanced Load Management Products

May 2007

FPF2000-FPF2007 IntelliMAXTM Advanced Load Management Products
Features
1.8 to 5.5V Input Voltage Range Controlled Turn-On 50mA and 100mA Current Limit Options Undervoltage Lockout Thermal Shutdown 1 A Shutdown Current Auto restart Fast Current limit Response Time 3 s to Moderate Over Currents 20ns to Hard Shorts Fault Blanking RoHS Compliant

General Description
The FPF2000 through FPF2007 is a family of load switches which provide full protection to systems and loads which may encounter large current conditions. These devices contain a 0.7 currentlimited P-channel MOSFET which can operate over an input voltage range of 1.8-5.5V. Switch control is by a logic input (ON) capable of interfacing directly with low voltage control signals. Each part contains thermal shutdown protection which shuts off the switch to prevent damage to the part when a continuous overcurrent condition causes excessive heating. When the switch current reaches the current limit, the part operates in a constant current mode to prohibit excessive currents from causing damage. For the FPF2000-FPF2002 and FPF2004FPF2006, if the constant current condition still persists after 10ms, these parts will shut off the switch and pull the fault signal pin (FLAGB) low. The FPF2000, FPF2001, FPF2004 and FPF2005, have an auto-restart feature which will turn the switch on again after 80ms if the ON pin is still
active. The FPF2002 and FPF2006 do not have this auto-restart feature so the switch will remain off until the ON pin is cycled. For the FPF2003 and FPF2007, a current limit condition will immediately pull the fault signal pin low and the part will remain in the constant-current mode until the switch current falls below the current limit. For the FPF2000 through FPF2003, the minimum current limit is 50mA while that for the FPF2004 through FPF2007 is 100mA. These parts are available in a space-saving 5 pin SC-70 package.

Applications
PDAs Cell Phones GPS Devices MP3 Players Digital Cameras Peripheral Ports Hot Swap Supplies

Ordering Information
Part
FPF2000 FPF2001 FPF2002 FPF2003 FPF2004 FPF2005 FPF2006 FPF2007

Current Limit [mA]
50 50 50 50 100 100 100 100

Current Limit Blanking Time [ms]
10 10 10 0 10 10 10 0

Auto-Restart Time [ms]
80 80 NA NA 80 80 NA NA

ON Pin Activity
Active HI Active LO Active HI Active HI Active HI Active LO Active HI Active HI

Top Mark
200 201 202 203 204 205 206 207

2007 Fairchild Semiconductor Corporation

www.fairchildsemi.com

FPF2000-FPF2007 Rev. E