rej03g0455_bcr10cm12lbds| Datasheet

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

BCR10CM-12LB (The product guaranteed maximum junction temperature of 150 C)
Parameter RMS on-state current Surge on-state current I2t for fusing Peak gate power dissipation Average gate power dissipation Peak gate voltage Peak gate current Junction temperature Storage temperature Mass Notes: 1. Gate open. Symbol IT (RMS) ITSM I2 t PGM PG (AV) VGM IGM Tj Tstg -- Ratings 10 100 41.6 5 0.5 10 2 40 to +150 40 to +150 2.0 Unit A A A2s W W V A C C g Conditions Commercial frequency, sine full wave Note3 360 conduction, Tc = 128 C 60Hz sinewave 1 full cycle, peak value, non-repetitive Value corresponding to 1 cycle of half wave 60Hz, surge on-state current

Typical value

Electrical Characteristics
Parameter Repetitive peak off-state current On-state voltage Gate trigger voltageNote2 Symbol IDRM VTM VFGT VRGT VRGT IFGT IRGT IRGT VGD Rth (j-c) (dv/dt)c Min. -- -- -- -- -- -- -- -- 0.2/0.1 -- 10/1 Typ. -- -- -- -- -- -- -- -- -- -- -- Max. 2.0 1.5 1.5 1.5 1.5 30Note6 30Note6 30Note6 -- 1.8 -- Unit mA V V V V mA mA mA V C/W V/us Test conditions Tj = 150 C, VDRM applied Tc = 25 C, ITM = 15 A, Instantaneous measurement Tj = 25 C, VD = 6 V, RL = 6 , RG = 330 Tj = 25 C, VD = 6 V, RL = 6 , RG = 330 Tj = 125 C/150 C, VD = 1/2 VDRM Junction to caseNote3 Note4 Tj = 125 C/150 C

Gate trigger currentNote2

Gate non-trigger voltage Thermal resistance Critical-rate of rise of off-state Note5 commutating voltage Notes: 2. 3. 4. 5. 6.

Measurement using the gate trigger characteristics measurement circuit. Case temperature is measured at the T2 tab 1.5 mm away from the molded case. The contact thermal resistance Rth (c-f) in case of greasing is 1.0 C/W. Test conditions of the critical-rate of rise of off-state commutating voltage is shown in the table below. High sensitivity (IGT 20 mA) is also available. (IGT item: 1) Test conditions Commutating voltage and current waveforms (inductive load)
Supply Voltage
Time (di/dt)c Time Time VD

1. Junction temperature Tj = 125 C/150 C 2. Rate of decay of on-state commutating current (di/dt)c = 5.0 A/ms 3. Peak off-state voltage VD = 400 V

Main Current Main Voltage (dv/dt)c

REJ03G0455-0300 Page 2 of 7

Rev.3.00

Nov 30, 2007