rej10j1053_e6000_s| Datasheet

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

1.3.3

Updating the Memory Content during Execution of the User Program

Updating the content of the [Memory] window during execution of the user program when either of the following conditions is satisfied causes the displayed values to be incorrect: [Enable read and write on the fly] in the [Configuration Properties] dialog box has been disabled Stepping (step-in, step-over, or step-out) is being performed The emulator is in sleep mode, software standby mode, watch mode, or subsleep mode. In those cases, the correct values will be displayed when the content of the window is updated after the program has stopped. This also applies to the windows [Disassembly], [Image View], [IO], [Watch], and [Waveform]. Updating of the [Monitor] window or [Watch] window by reading values with the monitoring function is available even with those conditions.

1.3.4

[Memory] Window

Do not enter a key at a blank in the [Memory] window. Otherwise, the values on the left of the cursor may be incorrect.

1.3.5

MEMORY_EDIT Command

Do not select the V/N option in the MEMORY_EDIT command. Writing to memory by the MEMORY_EDIT command always requires no verification.

1.3.6

MEMORY_FILL Command

Do not select the V/N option in the MEMORY_FILL command. Writing to memory by the MEMORY_FILL command always requires verification.

1.3.7

MEMORY_MOVE Command

Do not select the V/N option in the MEMORY_MOVE command. Writing to memory by the MEMORY_MOVE command always requires verification.

1.3.8

Verification of Memory

Use the FILE_VERIFY command to verify memory. Do not use [Verify Memory...] in the [File] menu.

1.3.9

FILE_LOAD Command

Do not specify V in the FILE_LOAD command. Use the FILE_VERIFY command to verify memory.

1.3.10

FILE_SAVE Command

The content of memory cannot be saved in the Elf/Dwarf2 format.

1.4

Emulation 1.4.1 Temporary Breakpoints
Run... (Run menu) Do not set temporary breakpoints to an area wherein PC Break (User Read-only) cannot be set. Otherwise, user program execution will not stop at the breakpoint. Moreover, the On Chip Breakpoint may remain. In this case, delete the breakpoint from the [Breakpoints] window.

1.4.2

Rate of Stepping

To perform stepping continuously with the [Image View] window or [Waveform] window open, select the rate of stepping either from 0 to 5.

2/5