E-STLC2416| Datasheet

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

E-STLC2416
BluetoothTM baseband with integrated flash
Features

Pin to pin compatible with the previous version STLC2415 Ericsson Technology Licensing Baseband Core (EBC) BluetoothTM specification compliance: V1.1 and V1.2 SW compatible with STLC2411-M28R400CT combination 2 layer class 4 PCB compatible Point-to-point, point-to-multi-point (up to 7 slaves) and scatternet capability Asynchronous Connection Oriented (ACL) logical transport link Synchronous Connection Oriented (SCO) links: 2 simultaneous SCO channels Supports Pitch-Period Error Concealment (PPEC) Improves speech quality in the vicinity of interference Improves coexistence with WLAN Works at receiver, no Bluetooth implication Adaptive Frequency Hopping (AFH): hopping kernel, channel assessment as Master and as Slave Faster Connection: Interlaced scan for Page and Inquiry scan, first FHS without random backoff, RSSI used to limit range Extended SCO (eSCO) links Standard BlueRF bus interface QoS Flush Clock support System clock input at 13 and 26 MHz LPO clock input at 3.2 and 32 kHz ARM7TDMI 32-bit C
PU Memory organization Integrated 4Mbit flash

LFBGA120 (10x10x1.4mm)

64KByte on-chip RAM 4KByte on-chip boot ROM Low power architecture with 2 different low power levels:Sleep mode and deep sleep mode HW support for packet types ACL: DM1, 3, 5 and DH1, 3, 5 SCO: HV1, 3 and DV eSCO: EV3, 5 Communication interfaces Synchronous Serial Interface, supporting up to 32 bit data and different industry standards Two enhanced 16550 UARTs with 128 byte FIFO depth 12Mbps USB interface Fast master I2C bus interface Multi slot PCM interface 16 programmable GPIOs 2 external interrupts and various interrupt possibilities through other interfaces Efficient support for WLAN coexistence in collocated scenario Ciphering support for up to 128-bit key Receiver Signal Strength Indication (RSSI) support for power-controlled links Separate control for external power amplifier (PA) for class1 power support. Software support Low level (up to HCI) stack or embedded stack with profiles Support of UART and USB HCI transport layers.

November 2006

Rev 1

1/36
www.st.com
36