VN610SP-E| Datasheet

VN610SP-E, VN610SPTR-E

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

VN610SP-E
SINGLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type VN610SP-E RDS(on) 10 m

Figure 1. Package
Iout
45 A

VCC
36 V

s OUTPUT s

CURRENT: 45 A

CMOS COMPATIBLE INPUT s PROPORTIONAL LOAD CURRENT SENSE
s

UNDERVOLTAGE AND OVERVOLTAGEn

SHUT-DOWN s OVERVOLTAGE CLAMP THERMAL SHUT DOWN s CURRENT LIMITATION s VERY LOW STAND-BY POWER DISSIPATION s PROTECTION AGAINST: n LOSS OF GROUND AND LOSS OF VCC s REVERSE BATTERY PROTECTION (*) s IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE
s

PowerSO-10TM

DESCRIPTION The VN610SP-E is a monolithic device made using STMicroelectronics VIPower M0-3 technology. It is intended for driving resistive or inductive loads with one side connected to ground. Active V CC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table).

This device integrates an analog current sense which delivers a current proportional to the load current (according to a known ratio). Active current limitation combined with thermal shut-down and automatic restart protect the device against overload. Device automatically turns off in case of ground pin disconnection.

Table 2. Order Codes
Package PowerSO-10TM
Note: (*) See application schematic at page 9

Tube VN610SP-E

Tape and Reel VN610SPTR-E

Rev. 1 October 2004 1/18