VND600SP-E| Datasheet

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

VND600SP-E
DOUBLE CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type VND600SP-E RDS(on) 30 m

Figure 1. Package
Ilim
25 A

VCC
36 V

s s s

DC SHORT CIRCUIT CURRENT: 25 A

CMOS COMPATIBLE INPUTS PROPORTIONAL LOAD CURRENT SENSE s UNDERVOLTAGE AND OVERVOLTAGE n SHUT-DOWN s OVERVOLTAGE CLAMP s THERMAL SHUT DOWN s CURRENT LIMITATION s VERY LOW STAND-BY POWER DISSIPATION s PROTECTION AGAINST: n LOSS OF GROUND AND LOSS OF VCC s REVERSE BATTERY PROTECTION (*) s IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE DESCRIPTION The VND600SP-E is a monolithic device made using STMicroelectronics VIPower M0-3 technology. It is intended for driving resistive or inductive loads with one side connected to ground. Active V CC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table).

PowerSO-10TM

This device has two channels in high side configuration; each channel has an analog sense output on which the sensing current is proportional (according to a known ratio) to the corresponding load current. Built-in thermal shut-down and outputs current limitation protect the chip from over temperature and short circuit. Device turns off in case of ground pin disconnection.

Table 2. Order Codes
Package PowerSO-10TM
Note: (*) See application schematic at page 9

Tube VND600SP-E

Tape and Reel VND600SPTR-E

Rev. 1 October 2004 1/18