VND830AEP-E| Datasheet

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

VND830AEP-E
DOUBLE CHANNEL HIGH SIDE DRIVER
TARGET SPECIFICATION

Table 1. General Features
TYPE VND830AEP-E
(*) Per each channel

Figure 1. Package
IOUT 6 A (*) VCC 36 V (*)

RDS(on) 60 m (*)

DC SHORT CIRCUIT CURRENT: 6A CMOS COMPATIBLE INPUTS PROPORTIONAL LOAD CURRENT SENSE UNDERVOLTAGE AND OVERVOLTAGE SHUT-DOWN OVERVOLTAGE CLAMP THERMAL SHUT-DOWN CURRENT LIMITATION VERY LOW STAND-BY POWER DISSIPATION

PowerSSO-24

PROTECTION AGAINST: LOSS OF GROUND AND LOSS OF VCC REVERSE BATTERY PROTECTION (**) IN COMPLIANCE WITH THE 2002/95/EC EUROPEAN DIRECTIVE

DESCRIPTION The VND830AEP-E is a monolithic device made using STMicroelectronics VIPower M0-3 technology. It is intended for driving any kind of load with one side connected to ground. Active VCC pin voltage clamp protects the device against low energy spikes (see ISO7637 transient compatibility table).

This device has two channels in high side configuration; each channel has an analog sense output on which the sensing current is proportional (according to a known ratio) to the corresponding load current. Built-in thermal shut-down and outputs current limitation protect the chip from over temperature and short circuit. Device turns off in case of ground pin disconnection.

Table 2. Order Codes
Package PowerSSO-24
Note: (**) See application schematic at page 9

Tube VND830AEP-E

Tape and Reel VND830AEPTR-E

Rev. 1 December 2004 1/15 This is preliminary information on a new product foreseen to be developed. Details are subject to change without notice.

VND830AEP-E Datasheet st Download PDF

Add this permalink to your bookmarks for future download of VND830AEP-E datasheet

Permalink: http://datasheet.emcelettronica.com/st/VND830AEP-E

VND830AEP-E DATASHEET