42092| Datasheet

Datasheet preview, take a look at Datasheets before downloading (Data Sheet is available on manufacturer site)

Type V-730P
Vishay Sprague

Film Capacitors High Frequency, Wrap-and-Fill, Metallized Polypropylene
FEATURES
Excellent AC performance Low Power dissipation Low dielectric absorption Close tolerance High stability

RoHS
COMPLIANT

PERFORMANCE CHARACTERISTICS
Operating Temperature: - 55 C to + 85 C Voltage derating: At + 105 C, 50 % of + 85 C rating ESR: 20 kHz to 100 kHz Capacitance Range: 0.022 uF to 10.0 uF Capactiance Tolerance: 20 %, 10 %, 5 % DC Voltage Rating: 100 WVDC to 630 WVDC AC Voltage Rating: 70 Vrms to 275 Vrms, 60 Hz to 400 Hz Dissipation Factor: 0.1 % maximum Measure all units at 1000 Hz at + 25 C DC Voltage Test: 200 % of rated voltage for 2 minutes AC Voltage Test: 130 % of rated rms voltage at 60 Hz for 15 seconds Insulation Resistance: Measured at 100 WVDC after a 2 minute charge. At + 25 C: 200 000 Megohm - Microfarads or 400 000 Megohm minimum. At + 85 C: 10 000 Megohm - Microfarads or 20 000 Megohm minimum. At + 105 C: 1000 Megohm - Microfarads or 2000 Megohm minimum. Vibration Test (Condition B): No mechanical damage, short, open or intermittent circuits. DC Life Test: 150 % of rated voltage for 1000 hours at + 85 C. No open or short circuits. No visible damage. Maximum CAP 1.0 % Minimum IR = 50 % of initial limit Maximu
m DF = 0.12 % Humidity Test: 95 % relative humidity at + 40 C for 250 hours. No visible damage. Maximum CAP 1.0 % Minimum IR = 20 % of initial limit Maximum DF = 0.12 % AC Life Test: 110 % of rated rms voltage at 60 Hz for 1000 hours at + 85 C. Maximum CAP 5 % Minimum IR = 50 % of initial limit Maximum DF = 0.12 %

PHYSICAL CHARACTERISTICS
Lead Pull: 5 pounds (2.3 kilograms) for one minute. No physical damage. Lead Bend: After three complete consecutive bends. No damage. Marking: Sprague trademark, type or part number, capacitance and voltage.

DIMENSIONS in inches [millimeters]
1.750 [44.45] Min. L 0.062 [1.57] 1.750 [44.45] Min. D Max.

Solid Tinned Wire 0.032 [0.81] Nominal Dia. (No. 20 AWG)

* Leads to be within 0.062" [1.57 mm] of center line at egrees but not less than 0.031" [0.79 mm] from edge.

Document Number: 42092 Revision: 16-Nov-07

For technical questions, contact: spresale@vishay.com

www.vishay.com 25